If you need to match images with a greater variety of colour and tone, you may need to use two or more colour sampler points in different areas. In my case the layer I needed to match was mostly a single colour and tone, so I only needed to match that one point. When this is done, your layers should now be well matched in both tone and colour. In the output box, enter the R value from the layer that you want to match the colour to.ĭo the same with the the Green and Blue channels, but obviously using the green and blue values of the layer that needs adjusting and the layer you to colour match. At the bottom of the adjustment window, in the input box, enter the R value you recorded for the layer that needs adjusting. Click on the curve to add an adjustment point. In the curves adjustment layer window, first select the Red Channel. A small arrow should appear to the left of the curves adjustment layer, indicating it is now clipped to the layer below. Select the curves layer, then Alt-click between the curves layer and the layer that needs correcting. To do this, ensure the curves layer is above the layer that needs adjusting. Now show (or hide if it was already showing) the layer that you want to colour match, and make another note of the different RGB values.Ĭreate a curves adjustment layer, and clip it to the layer you want to colour correct. Make sure that you don't have a layer mask selected as the active layer, then make a note of the RGB values. ![]() Now, open the Info palette window Window > Info, and you can see the colour sampler values listed above the document size. Generally we will want to sample a size such as 11x11 Average or 31x31 Average. If you right-click on the marker, you can change the sampling size. ![]() You should see a colour sampler marker appear where you clicked. Alternatively, instead of shift-clicking with the eyedropper tool, you can single click with the color sampler tool, both do the same thing. To do this, select the eyedropper tool and shift-click on the desired area. First, you need to place a colour sampler on an area where both the layers that you want to colour match overlap.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |